Clearing Function Sets - Yamaha RX Z9 - AV Receiver Owner's Manual

4
Press MACRO again when the operation
sequence you want to program is complete.
Memory back-up
If the remote control is without batteries for more than
3 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. If the memory is cleared, insert new batteries,
set up the manufacturer code(s) and program any
acquired functions that may have been cleared.

Clearing function sets

You can clear all changes made in each function set, such
as learned functions, macros, renamed component
(source) names and setup manufacturer codes.
1
Press CLEAR by using a ballpoint pen or
similar object.
CLEAR
y
Complete each of the following steps within 30 seconds.
Otherwise, the learning mode is automatically canceled. In
this case, press CLEAR again.
2
Press k/n to select the clear mode.
L:DVD
(L: name of a component)
Clears all learned functions for the respective
component control area. Press an input selector
button to select the component.
L:AMP
Clears all learned functions for this unit's control
area.
L:ALL
Clears all learned functions.
M:ALL
Clears all programmed macros.
RNAME
Clears all renamed component (source) names.
FCTRY
Clears all remote functions and returns the remote
to the factory settings.
3
Press and hold CLEAR again for about 3
seconds.
"C:OK" appears in the display window.
CLEAR
Note
"C:NG" appears in the display window if the operation was
unsuccessful. In this case, start over from step 2.
4
Press CLEAR to exit the clear mode.
Once you have cleared a learned function or macro
for a button, the button reverts to the factory setting.
CLEAR
Note
"ERROR" appears in the display window under the following
circumstances:
– When a button other than a cursor or ENTER is pressed.
– When more than one button is pressed simultaneously.
– When MACRO ON/OFF or 10KEY/AMP is switched to
another position.
REMOTE CONTROL FEATURES
93