Page 1
Owner’s Manual Model IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to install or use this heater. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. 7211460100R00...
Welcome & Congratulations thank you and congratulations for choosing to purchase an electric heater from new air, the world leader in electric heaters. Please carefully read and save these instructions. CAUTION: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
IMPORTANT INSTRUCTIONS ① Read all instructions before ⑥ Do not use outdoors. using this appliance. ⑦ the heater is not intended for ② the heater is hot when in use. use in bathrooms, laundry areas to avoid burns, do not let bare and similar indoor locations.
IMPORTANT INSTRUCTIONS soft surfaces, like a bed, where the red light rurns on, immediately openings may become blocked. turn heater off and inspect for any objects on or adjacent ⑬ All electrical heaters have hot to the heater that may cause and arching or sparking parts high temperatures.
IMPORTANT SAFETY INSTRUCTIONS grounding Instructions Figure 1: this heater is for use on 240 Plug and outlet configuration for 240 Volts. the cord has a plug as Volt, 20 amp circuit shown on Figure 1. no adapter should be used with this unit. the type outlet is a 240 Volt grounding Ground outlet.
Heater Installation HEATER LOCATION AND CLEARANCES the heater is intended for use located on a hard floor, table top, desk or on shelf, and the like, or suspended on a wall or ceiling by means of provided hanger bracket. When suspended from wall or ceiling heater should be located the use of the hanger bracket along outside walls to provide...
Page 8
Heater Installation Insert carriage bolt into Figure 3 Hanger square opening of heater bracket handle. slide spacer over the carriage t-Handle bolt shaft and insert in hanger bracket opening and Lock washer hold them in position. spacer slide lock washer and thread on t-Handle onto carriage Carrage bolt, turn to tighten.
Operation Setting the Thermostat NOTE: Heater is equipped with a fan delay to dissipate Before connecting or residual heat from the element. disconnecting plug, turn Heater fan will run for a brief knob fully counterclockwise. period after heater has reached (Figure 4) room temperature.
30 minutes for the heater to cool before attempting any Warranty newair Electric Heaters are tested the owner/user assumes all other risks, and inspected prior to shipment and if any, including the risk of any direct,...
Need help?
Do you have a question about the G70 and is the answer not in the manual?
Questions and answers