Assembly - ButterBall 20010109 Operation Manual

ASSEMBLY INSTRUCTIONS
3
1
Tabs
Step 2
Step 1
Insert inner pot (5) into outer shell (1).
Insert hinge tab on lid (3) into
outer shell (1). Lid will snap into place
Note: Insert inner pot at an angle to fit
when assembled correctly.
valve into side opening of outer shell.
Note: To remove lid push tabs together
on outer shell and pull lid up as shown.
4
5
Drain Clip
Drain Clip
Mounting Hole
1
Step 4 Step 5
Place basket (4) inside inner pot (5). Insert tabs on valve door (2) into
slots on outer shell (1).
Note: To remove valve door press
release button and slide cover off.
• Do NOT store power cord in storage compartment until unit has cooled.
• Do NOT operate appliance with a damaged cord, plug, or after appliance malfunctions, or
has been damaged in any manner. Contact Masterbuilt Customer Service for assistance at
1-800-489-1581.
3
Safety Switch
5
1
Mounting
Bracket
Step 3
Slide control panel and element (6)
down onto mounting bracket (shown in
Step 2) on side of outer shell (1).
Note: Control panel must be correctly
attached for appliance to operate.
A built in safety switch on control panel
will prevent element from heating if not
mounted properly.
Storage for
Power Cord
and Valve
Spout
Release
Button
2
7
Step 6
Insert breakaway cord (7) into
connection on outer shell (1).
Make sure "This Side Up" is shown
on top for proper connection.
CAUTION
6
1
1