Table of Contents
Advertisement
FFM100 User's Manual
3.4 Configuring Channel #0
3.4.1 Enabling/Disabling Channel #0
By default, the channel is enabled and will measure the flow rate and transmit it over the
NMEA 2000 network. If this parameter is programmed to "Disable", the channel will be
completely disabled and will not measure flow rate nor transmit it over the NMEA 2000
network.
3.4.2 Configuring Channel #0 Engine Instance
Program this parameter to match the desired engine instance number of the flow rate and total
fuel used for this channel. You can program this parameter to any value between 0 and 252.
3.4.3 Configuring Channel #0 Engine Label
Program this parameter with a text string which identifies the particular parameter being
monitored by this channel. Maretron display products will display this label text when you are
selecting data to display.
3.4.4 Configuring Channel #0 K-factor
Program this parameter to match the K-factor that appears on the flow sensor connected to
this channel.
3.4.5 Configuring Channel #0 Data Damping Period
You can configure a damping parameter to smooth the flow rate readings or make them more
responsive. The data damping is configurable between 0.2-25.0 seconds. The default data
damping period is 3.0 seconds.
3.4.6 Resetting the Total Volume Recorded for Channel #0
The FFM100 maintains the total volume recorded in EEPROM, so that it is maintained across
power cycles. Select this menu entry to reset the total volume recorded to zero.
3.4.7 Configuring Channel #0 Temperature Instance
Program this parameter to match the desired instance number of the temperature reading for
this channel. You can program this parameter to any value between 0 and 252. The default
value for this parameter is 0.
3.4.8 Configuring Channel #0 Temperature Source
Program this parameter to match the desired instance number of the temperature reading for
this channel. You can program this parameter to any value between 0 and 252. The default
value for this parameter is 129 (User Defined).
Page 14
the two flow rate measurements as separate parameters over the NMEA
2000 network.
Revision 1.2
Advertisement
Table of Contents
