There Are Problems When Operating The Dishwasher; The Wash Results Are Not Satisfactory - AEG Electrolux FAVORIT 35085 VI Instruction Book

Operating instructions
Once the checks have been carried out, press the programme
selection/cancel button and close the dishwasher's door. The
programme will continue from the point at which it was interrupted. If
the fault code reappears contact your local Service Force Centre.
For other combinations of fault codes not described in the above chart
will appear, please contact your local Service Force Centre.

...there are problems when operating the dishwasher

Fault
The programme does not
start
There is a whistling noise
during washing

...the wash results are not satisfactory

The dishes are not clean
The incorrect washing programme has been selected.
The dishes were arranged in such a way as to stop water reaching all
parts of the surface. The baskets must not be overloaded.
The spray arms do not rotate freely due to incorrect arrangement of
the load.
The filters in the base of the washing compartment are dirty or
incorrectly positioned.
Too little or no detergent has been used.
Where there are limescale deposits on the dishes; the salt container
is empty or the wrong level of the water softener has been selected.
The drain hose connection is not correct.
The salt container cap is not properly closed.
34
Possible cause
The dishwasher door has not
been properly closed.
The main plug is not plugged
in.
The fuse has blown in the
household fuse box.
Delay start has been selected.
The whistling is not a cause
for concern.
Solutions
Close the door.
Insert the mains plug.
Replace the fuse.
If dishes are to be washed
immediately, cancel the
delay start.
Use a different brand of
detergent.