Page 2
State of California, USA. The State of California, County of Santa Clara shall be the exclusive venue for the resolu- tion of any such disputes. Acnodes 's total liability for all claims will not exceed the price paid for the hardware product.
RMC7132 chassis. Chapter 2: Server Installation This chapter describes the steps necessary to install the Acnodes RMC7132 into a rack and check out the server configuration prior to powering up the system. If your server was ordered without the processor and memory components, this chapter will refer you to the appropriate sections of the manual for their installation.
CHAPTER 1 INTRODUCTION Overview The Acnodes RMC7132 is a high-end single processor, 1U rack- mount server. The RMC7132 is comprised of two main subsystems: the RMC7132 chassis and the embedded board. Please refer to our web site for informa- tion on operating systems that have been certified for use with the RMC7132.
RMC 7132 1U Rackmount System Motherboard Features At the heart of the Acnodes RMC7132 lies the embedded board, a single processor mother- board based upon Intel's X58 chipset. Below are the main features of the embedded board. Processor The embedded board supports single Intel® Core™ i7, Core™ i7 Extreme pro- cessors and future Intel Nehalem processor families (next generation Intel Xeon®...
Unpacking the System You should inspect the box the Acnodes RMC7130 was shipped in and note if it was damaged in any way. If the server itself shows damage, you should file a damage claim with the carrier who delivered it.
2-4 Installing the System into a Rack This section provides information on installing the Acnodes RMC7132 into a rack unit. If the system has already been mounted into a rack, you can skip ahead to Sec- tions 2-5 and 2-6. There are a variety of rack units on the market, which may mean the assembly procedure will differ slightly.
Page 21
Installing the Server into a Telco Rack If you are installing the Acnodes RMC7132 into a Telco type rack, follow the directions given on the previous pages for rack installation. The only difference in the installation procedure will be the position- ing of the rack brackets to the rack.
1U Rackmount System 6-3 System Fans Two 10-cm blower fans provide the cooling for the Acnodes RMC7132. The chassis includes air seals under the blower fans and at the chassis cross section, which separates the drive bay area from the serverboard area of the chassis to promote better airflow. It is highly important that the air seal is properly installed and making a good seal in order for the cooling air to circulate properly through the chassis.
1U Rackmount System 6-5 Power Supply The Acnodes RMC7132 has a single 200 watt power supply. This power supply has the capability of operating at 100 - 240 input volts. Power down the system and then unplug the AC power cord to completely remove power from the system before removing the power supply.
Need help?
Do you have a question about the RMC 7132 and is the answer not in the manual?
Questions and answers