Introduction; Features; Accessories; Carton Inventory - Chamberlain KPR2000 Manual

INTRODUCTION

The LiftMaster KPR2000 is a single entry multi-function Access Controller with integrated keypad and card reader. It is designed and manufactured to
perform in a wide range of indoor, outdoor, and harsh environments.
The KPR2000 supports up to 2000 users in multiple access configurations (Card Only, Card or PIN, or Card + PIN). The built in 125 KHz card reader
supports industry standard 26 bit Wiegand and 30 bit Sentex Wiegand proximity card formats. It can also be programmed to accept inputs from, or
provide output to other 26~37 bit Wiegand input/control devices. The KPR2000 offers advanced programming features like; block enrollment,
advanced relay programming, and Panic PINs/Cards (which open the entry and set off the alarm).

Features

• Waterproof (IP68) (meets or exceeds N4)
• Vandal Resistant Enclosure
• Backlit Keypad
• Multi-color LED status display
• Integrated Alarm Buzzer & Output
• One Programmable Relay Output
• Stand Alone or Pass-Through Operation
• 2000 Users (Card/PIN/Card+PIN)
• 10 Panic Card/PIN Codes
• Low power consumption (50mA)
• Anti-Tamper Alarm
• Latch Mode to hold door or gate open

Accessories

• Model PEDS44 Low Profile Access Pedestal
• Model PEDAD 4 x 4 Pedestal Adaptor
• Model PS12V2A 12 Vdc, 2 Amp Power Supply
• Model LCC26 LiftMaster 26 bit Wiegand Card

Carton Inventory

NOT SHOWN: User's Manual
KPR2000
Keypad/Proximity Reader/Controller
Diode IN4007 (For Relay
circuit protection)
Manag er A dd Card
Manager Add Card
Self Tapping Screws #8 x 1"
Manag er Delete Card
Wall Anchors #6 x 1 1/8" Manager Delete Card
Security Screwdriver
(T-10 Security Torx Driver)
Specifi cations
User Capacity . . . . . . . . . . 2000 Cards/PINS plus 10 Panic Cards/PINS
Operating Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 ~ 24 Vdc
Idle Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ~ 50mA
Active Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ~ 80mA
Keypad . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Key (3x4)
Proximity Card Reader . . . . . . . . . . . . . . . . . .Industry Standard 26 bit
Radio Technology . . . . . . 125 KHz Industry Standard Proximity Card
Read Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 inch - 2.5 inches
Wiring Connections . . . . . . . . . . . . . .Relay Output, REX, DOTL, Alarm,
Relay. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . One (NO, NC, Common)
Adjustable Relay Output Time . . 1 ~ 99 Seconds (5 seconds default)
Adjustable Alarm Output Time . . . . . 0 ~ 3 Minutes (1 minute default)
Lock Output Load . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Amp Maximum
Alarm Output Load . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Amp Maximum
Wiegand Interface . . . . Wiegand 26, 30, & 34 bit Format Input & Output
Environment . . . . . . . . . . . . . . . . . . . . . . . . . .Meets or exceeds IP68
Operating Temperature . . . . . . . . . . . .-20°C ~ 60°C, or -4°F ~ 140°F
Operating Humidity . . . . . . . . . . . . . . . 10% ~ 90% Non-Condensing
Physical . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Zinc-Alloy Enclosure
Surface Finish . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Powder Coat
Dimensions . . . . . . . . . . . . . . . . . . . L:128mm x W:82mm x D:28mm
Unit Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Pound
Shipping Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.4 Pounds
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
2
and 30 bit (Sentex)
Wiegand (in/out)