English Push MODE/Power Hold MARK 2 sec. (repeat x times) (distance changes to “0”) (Make sure satellite icon stops blinking before marking a location) 1. Select a Location Icon 2. Mark Your Location (House, Car or Star) The BackTrack will remember where that spot was, Quick Reference even when turned off.
English Using Your Bushnell BackTrack Button Operation Guide: PUSH=briefly press and release the button HOLD=keep the button pressed down for 2 seconds 1. Twist the round battery cover on the back of the BackTrack clockwise to open it (see photo), and insert two “AAA” alkaline or lithium batteries in the direction marked inside the battery compartment.
Page 5
English Using Your Bushnell BackTrack To mark the location (store it in the BackTrack’s memory under your selected HOLD MARK Location icon), button until the distance indication changes to “0”. It does not matter which direction you face when marking the location (as a stored GPS location is just a point or “dot”).
Page 6
GPS reception inside a car. Liability Notice: In no event shall Bushnell be liable for any incidental, special, indirect or consequential damages, whether resulting from the use, misuse, or inability to use this product or from defects in the product.
Lenexa, Kansas 66214 Richmond Hill, Ontario L4B 2M9 For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information. In Europe you may also contact Bushnell at: Bushnell Germany GmbH European Service Centre Mathias-Brüggen-Str.
Need help?
Do you have a question about the BackTrack 36-0055 and is the answer not in the manual?
Questions and answers