Quick Guide For Menu Operation - JVC LT-32DM22 Instruction Manual

To select the video input source
To view a signal from another device connected to
your LCD TV, such as a VCR player, press INPUT
SELECT, then press ▲ or ▼ or corresponding
Number buttons (0-7), then press ENTER. You
can select TV, Video1, Video2, Component, HDMI1,
HDMI2, PC or DVD depending on which input jacks
you used to connect your devices.
Input Select
0.TV
1.Video1
2.Video2
3.Component
4.HDMI1
5.HDMI2
6.PC
7.DVD
[0-7]:Select
CH /
Press and release CH
automatically stops at the next channel set into
memory.
For proper operation, before selecting channels, they
should be set into the memory. See "Memorizing
channels" on page 19.
DISPLAY
Press DISPLAY to display the current information on
the screen.
When the TV receives a digital signal, the digital
information will appear.
62-1 HDTV Moving Picture... Sleep Timer
Off
CH-1 TV-MA
Digital Air English
No Program Information is available
Full
1080i
• Channel number
• Channel label (if preset)
• V-Chip rating
• Sleep timer
• Program guide
• Resolution
When the TV receives an analog signal, the analog
information will appear.
14 Sleep Timer
Off
G
Analog Cable
Mono
Full
480i
• Channel number
• V-Chip rating
• Sleep timer
• Audio information
(Stereo, SAP or Mono)
Press DISPLAY again to clear the call display.
NOTE:
• After a few seconds, DISPLAY screen will return to
normal TV operation automatically.
/ . The channel
• Station name
• Broadcast program name
• Signal type
• Audio language
• Picture size
• Channel label (if preset)
• Signal type
• Picture size
• Resolution
RECALL
This button allows you to go back to the last channel
selected by pressing RECALL. Press RECALL again to
return to the last channel you were watching.
MUTING
Press MUTING to switch off the sound. The TV's
sound will be silenced and "Muting" will appear on
the screen. The sound can be switched back on by
pressing this button again or the VOL + or –.
SLEEP
To set the TV to turn off after a preset amount of time,
press SLEEP on the remote control. The clock will
count up 10 minutes for each press of the SLEEP
button (Off, 0h 10m, 0h 20m, ..., 2h 0m). After the
sleep time is programmed, the display will appear
briefly every ten minutes to remind you that the sleep
timer is operating. To confirm the sleep timer setting,
press SLEEP and the remaining time will be dis-
played for a few seconds. To cancel the sleep timer,
press SLEEP repeatedly until the display turns to Off.
Quick guide for menu
operation
Call menu and for example: Select Language.
1
Press INPUT SELECT to select TV mode.
2
Press TV MENU. The TV menu screen will appear.
Main Menu
>>
Picture
Audio
Channel
CH
Lock
Setup
3
:Select ENTER :Set
Press ▲ or ▼ to select "Setup", then press ▶ or
ENTER.
4
Press ▲ or ▼ to select "Language", then press ◀
or ▶ to select the desired language.
...on the following pages the menu can be called
in the same way as here.
5
Press EXIT to return to the normal screen.
NOTE:
• If no buttons are pressed for more than about 60
seconds, the menu screen will return to normal
operation automatically.
17