Removing Collected Water - Frigidaire FAD301NWD Use & Care Manual

Operating Instructions
(continued)
1. To shut the unit down, rotate the humidity knob to the OFF position.
NOTE:
While the power indicator lit, rotate the humidity knob to the OFF position or removing the plug will extinguish this light.

Removing Collected Water

1. Emptying the Bucket:
a. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate.
b. Do not move the unit at this time otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove the bucket as shown in the photographs below and empty the bucket.
WARNING
Discard water from bucket. Water is not potable and cannot be used for drinking.
e. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again.
f. You should hear a click when the bucket is in the correct position
If the bucket full light does not extinguish, check that the float is
correctly snapped in place as indicated by the diagram.
NOTE:
The foam embedded under the float(shown in the sideward
diagram) is a functional part, which can not be removed.
2009 Electrolux Home Products, Inc.
Operating Instructions
Foam
All rights reserved.
5