Emulex Ezpilot; Hp Command View Eva; Installation Instructions - HP StorageWorks 4000/6000/8000 - Enterprise Virtual Arrays Release Note

Emulex EZPilot

EZPilot is used during installation of the EVA4000 SAN Starter Kit to simplify SAN configuration. EZPilot
can also be used to perform basic storage provisioning tasks, such as creating and deleting virtual disks.

HP Command View EVA

HP Command View EVA is a tool for managing all aspects of storage system operation. In addition
to provisioning, HP Command View EVA enables you to monitor the storage system and troubleshoot
problems.
Table 2 identifies the supported management tasks.
Table 2 Supported management tasks
Task
Manage virtual disks
Manage disk groups
Manage HBAs
Manage Fibre Channel switch
View storage system status
Manage replacement of hardware
Access controller event logs
Upgrade storage system firmware
Shut down/restart storage system
Manage data replication

Installation instructions

For information about installing the EVA4000 SAN Starter Kit, see the following:
• HP StorageWorks EVA4000 SAN Starter Kit quick installation
• Emulex EZPilot User Manual
CAUTION:
When installing the EVA4000 SAN Starter Kit, be sure to use the EZPilot installation CD, which installs
all of the required components. Do
doing so will disrupt the installation process.
Installed components
Table 3 identifies the components installed on the server for each EZPilot installation configuration.
4
not
use any of the other installation CDs included with the product;
EZPilot HP Command
View EVA
Yes Yes
Yes
No
Yes
No
Yes No
Yes Yes
No Yes
No Yes
Yes
No
Yes
No
No Yes