Sony Handycam DCR-SX22E Instruction & Operation Manual page 13

4
When the battery is charged, disconnect the AC Adaptor from the DC IN
jack of your camcorder.
Tips

See page 76 on recording and playing time.

When your camcorder is on, you can check the approximate amount of remaining battery power with the

remaining battery indicator at the upper left on the LCD screen.
Charging time
Approximate time (min.) required when you fully charge a fully discharged battery pack.
Battery pack
NP-FV30 (supplied)
NP-FV50
NP-FV70
NP-FV100
Times measured with the camcorder at 25

10 C to 30 C (50 °F to 86 °F) is recommended.
 
To remove the battery pack
Close the LCD screen. Slide the BATT (battery) release lever () and remove the battery
pack ().
To use a wall outlet (wall socket) as a power source
Make the same connections as "Step 1: Charging the battery pack. " Even if the battery pack is
attached, the battery pack is not discharged.
Charging the battery pack abroad
You can charge the battery pack in any countries/regions using the AC Adaptor supplied with
your camcorder within the AC 100 V - 240 V, 50 Hz/60 Hz range.
Notes
Do not use an electronic voltage transformer.

Charging time
115
155
195
390
C (77 °F).

GB
1