Intel D845EBG2 - Desktop Board Motherboard Product Manual page 49

Table 13. Peripheral Configuration Submenu (continued)
Feature Options
• Disabled
Parallel Port
• Enabled
• Auto (default)
• Output Only
Mode
• Bi-directional
• EPP
• ECP
• 378 (default)
Base I/O Address
(This feature is present
• 278
only when Parallel Port
is set to Enabled)
• IRQ 5
Interrupt
(This feature is present
• IRQ 7 (default)
only when Parallel Port
is set to Enabled)
• 1
DMA Channel
(This feature is present
• 3 (default)
only when Parallel Port
Mode is set to ECP)
• Disabled
Audio Device
• Enabled (default)
• Disabled
LAN Device
(This feature is present
• Enabled (default)
only when there is
onboard LAN)
Description
Configures the parallel port.
Auto assigns LPT1 the address 378h and the
interrupt IRQ7.
An * (asterisk) displayed next to an address indicates a
conflict with another device.
Selects the mode for the parallel port. Not available if the
parallel port is disabled.
(default) Output Only operates in AT
Bi-directional operates in PS/2-compatible mode.
EPP is Extended Parallel Port mode, a high-speed
bi-directional mode.
ECP is Enhanced Capabilities Port mode, a high-speed
bi-directional mode.
Specifies the base I/O address for the parallel port.
Specifies the interrupt for the parallel port.
Specifies the DMA channel.
Enables or disables the onboard audio subsystem.
Enables or disables the LAN device.
Using the Setup Program
†
-compatible mode.
49