Time To Ready; Power Specifications; Power Consumption - Maxtor STM940215A - MobileMax 40 GB Hard Drive Product Manual

2.8

Time to ready

Time to ready
Power-on to Ready (sec)
Standby to Ready (sec)
2.9

Power specifications

The drive receives DC power (+5V) through the interface connector.
2.9.1

Power consumption

Power requirements for the drives are listed in the table on page 12. Typical power measurements are based
on an average of drives tested, under nominal conditions, at 25°C ambient temperature.
• Spinup power
Spinup power is measured from the time of power-on to the time that the drive spindle reaches operating speed.
• Seek mode
During seek mode, the read/write actuator arm moves toward a specific position on the disc surface and does
not execute a read or write operation. Servo electronics are active. Seek mode power is measured based on
three random seek operations every 100 msecs. This mode is not typical.
• Read/write power and current
Read/write power is measured with the heads on track, based on three 63 sector read or write operations
every 100 msecs.
• Idle mode power*
Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in
a random track location.
• Standby mode
During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/
write electronics are in power-down model.
Table 4: DC power for 2 disk models
Power dissipation
Spinup (typical)
Seek
Read
Write
Idle, performance
Idle, active*
Idle, low power mode*
Standby
Sleep
*During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and
power to operational levels.
12
Typical Max @ 25
3.5 8.0
3.0 8.0
+5V average (25° C)
1.0 amps
2.0 watts
2.0 watts
1.8 watts
1.7 watts
0.99 watts
0.8 watts
0.26 watts
0.26 watts
°
C
MobileMax Product Manual, Rev. A