2.5
Recording and interface technology
Technology
Interface
Recording density BPI (bits/inch typical)
Track density TPI (tracks/inch typical)
2
Areal density (Gbits/inch
Spindle speed (RPM) (± 0.2%)
I/O data-transfer rate (Mbytes/sec max)
Interleave
Cache buffer
2.6
Physical characteristics
Height
(mm)
(inches)
Width
(mm)
(inches)
Length
(mm)
(inches)
Typical weight
STM980215A
STM960212A
STM940215A
2.7
Seek time
Seek measurements are taken with nominal power at 25°C ambient temperature. All times are measured using
drive diagnostics. The specifications below are defined as follows:
• Track-to-track seek time is an average of all possible single-track seeks in both directions.
• Average seek time is a true statistical random average of at least 5,000 measurements of seeks between
random tracks, less overhead.
Typical seek times (msec)*
Track-to-track
Average
Full-stroke
Average latency
*Measured in performance mode
Note.
These drives are designed to consistently meet the seek times represented in this manual. Physical
seeks, regardless of mode (such as track-to-track and average), are expected to meet or exceed the
noted values. However, due to the manner in which these drives are formatted, benchmark tests that
include command overhead or measure logical seeks may produce results that vary from these speci-
fications.
MobileMax Product Manual, Rev. A
max)
9.5 +/–0.2
0.374 +/–0.008
69.85 +/–0.25
2.750 +/–0.010
100.50 +/–0.25
3.957 +/–0.010
100 grams
0.220 pounds
Read
1.0
11.0
22.0
5.56
Specification
Parallel ATA
Up to 835k
Up to 150k
Up to 132
5,400
100 (Ultra DMA mode 5)
1:1
2 Mbytes (2,048 kbytes)
Write
1.5
13.0
24.0
5.56
11