Sony KLV-32S400A - 32" LCD TV Operating Instructions Manual page 34

Problem
Good picture, but noisy sound
Some tiny black points and/or
bright points appear on the
screen
No colour on programmes
No colour or irregular colour
when viewing a signal from the
Y, P /C , P /C jacks of
B B R R
1 or 2
Picture flashes initially when
changing to HDMI mode or
switching on the TV with HDMI
mode
Sound
No sound, but good picture
Stereo broadcast sound
switches on and off, or is
distorted; the sound switches
between stereo and monaural
frequently
General
The TV turns off automatically
(the TV enters standby mode)
The TV turns on automatically
Some input sources cannot be
selected
The remote does not function
The "Store Display Mode: On"
message appears on the
screen
The wide screen mode
changes spontaneously when
"Auto Wide" is "On"
34
GB
Cause/Remedy
• The TV system setting is inappropriate.
• If the sound of all the channels are noisy, perform "Auto Tuning" in the "Channel
Set-up" menu to preset the channel again (page 30).
• If the sound of some channels is noisy, select the channel, then perform "Manual
Programme Preset" in the "Channel Set-up" menu, and select the appropriate TV
system ("TV System") (page 31).
• The picture of a display unit is composed of pixels. Tiny black points and/or bright
points (pixels) on the screen do not indicate a malfunction.
• Select "Reset" in the "Picture" menu to return to the factory settings (page 23).
• Check the connection of the Y, P
• Make sure that the Y, P
respective jacks.
/
• This is probably caused by the authentication process between HDMI equipment
and the TV. It does not indicate a malfunction.
• Press 2 +/– or % (Mute).
• Check if the "Speaker" is set to "TV Speaker" from the "AV Set-up" menu in "Set-
up" menu (page 27).
• The antenna connection is loose or the antenna cable is damaged. Check the cable
and connection on the TV, VCR, and on the wall (page 5).
• Adjust the antenna direction for the minimum interference. Contact a Sony dealer
for advice.
• Signal transmission is low. Try using a booster. Otherwise, use the fine tuning
("AFT") function (page 31).
• Check if the "Sleep Timer" is activated, or confirm the "Duration" setting of "On
Timer" (page 28).
• Check if the "On Timer" is activated (page 28).
• Select "Video Labels" in the "AV Set-up" menu and cancel "Skip" of the input
source (page 26).
• Replace the batteries.
• Select "Factory Settings" in the "Set-up" menu (page 28).
• During a transition between two programmes, the TV detects the optimum wide
screen mode. During this period, an irregular wide screen mode may appear.
• The wide mode is switched automatically according to the revised signal with a
Wide ID signal.
• The "Auto Wide" feature stops working temporarily when you press
resumes after a while. To fix in the manually selected wide screen mode, set "Auto
Wide" to "Off" in the "Screen" menu (page 25).
/C , P /C jacks of
B B R R
/C , P /C jacks of /
B B R R
/ 1 or 2.
1 or 2 are firmly seated in their
, and