Product Overview; Led Panel - Cisco Linksys WUMC710 User Manual

Linksys WUMC710

Product Overview

Thank you for choosing the Linksys Wireless-AC Universal Media Connector
The media connector can connect any wired Ethernet device to your wireless
network The media connector is based on Wireless-AC, so it is compatible
with Wireless-N (5 GHz) and Wireless-A routers or access points For first-
time installation, follow the steps in the Quick Installation Guide To configure
advanced settings, use the convenient browser-based utility "

LED panel

Wireless
(Blue) The Wireless LED lights up when there
is a wireless connection The LED flashes when the media
connector is actively sending or receiving data over the
wireless network
Wi-Fi Protected Setup Button If your router supports Wi-
Fi Protected Setup and uses WPA or WPA2 security, then
you can use Wi-Fi Protected Setup to automatically connect
the media connector To use Wi-Fi Protected Setup, refer to
"Wireless > Basic Wireless Settings" on page 7
Wi-Fi Protected Setup LED
(Blue/Amber) The LED flashes
blue for two minutes during Wi-Fi Protected Setup It
lights up blue when wireless security is enabled If there
is an error during the Wi-Fi Protected Setup process, then
the LED lights up amber Make sure the network router
supports Wi-Fi Protected Setup Wait until the LED is off,
and then try again
Ethernet
(Blue) The Ethernet LED lights up when there
is a wired connection The LED flashes when the media
connector is actively sending or receiving data over the
Ethernet port(s)
Power
(Blue) The Power LED lights up when the media
connector is powered on
Product Overview
2 2