Procedures - Wyse C30LE Installation Manual

4
Chapter 2

Procedures

Step 1: Remove the Top Cover
1. Perform a proper shutdown of the cloud client by closing all files and ending your
session, and then press the power button to turn off the cloud client.
2. Unplug the power cord and power adapter, remove all of the cables from the rear of the
cloud client, and then detach any support feet.
3. Position the cloud client horizontally, remove the screw from the back of the cloud
client using a small Phillips screwdriver, and then use a plastic alignment tool to pry
and loosen the top cover as shown in Figure 2.
Figure 2 Removing the top cover
4. Lift the top cover to remove it and expose the main board as shown in Figure 3. Notice
that the rear of the cloud client is positioned at the bottom of the photo.
Step 2: Install the Flash Module
1. Note where the connector of the flash module is located in Figure 3. Remove the
existing flash module. Use needle-nose pliers to squeeze the plastic standoff lock as
you rock the flash module back and forth to remove it from the socket.
Figure 3 Removing the existing flash module
Caution
Follow all precautions listed in the Quick-Start Guide that came with your
cloud client for disconnecting and reconnecting the cloud client.
Warning
Flash modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis
and keep that contact with the chassis during the installation process.