San Switch 2/32 Hardware Updates - HP StorageWorks 2/32 - SAN Switch Release Note

SAN Switch 2/32 Hardware Updates

6. Clear the switch of all zoning information by running the following set of
commands:
cfgdisable
cfgclear
cfgsave
7. Connect the switch to the fabric through an ISL cable. Once the switch is
connected to the fabric, the zone configuration information for the fabric will
automatically copy to the switch.
8. Clear the Management server Platform Database from the switch with the
msPlClearDB command.
SAN Switch 2/32 Hardware Updates
The following section lists hardware updates for the SAN Switch 2/32.
Important Information Regarding the HP System/e Rack
Mounting Hardware
HP highly recommends installing the switch in the optional System/e Rack using only
the hardware supplied with the rack.
For example, when installing the two inner rails on either side of the switch, you must
use the six #8-32 x 5/16 Phillips pan-head screws, and #8 flat washers as specified in
the hp StorageWorks SAN Switch 2/32 Installation Guide. The #8 flat washer shortens
the #8-32 x 5/16 Phillips pan-head screw so that it does not interfere with the internal
components of the switch.
IMPORTANT: Using longer than recommended screws to install your switch into the HP
System/e Rack Kit will result in physical damage to the switch motherboard.
6 SAN switch 2/32, version 4.0.2b release notes