Name Of The Button On The Tool Bar; Icon Display For The Target - Sanyo PLC-XU300 - XGA LCD Projector Owner's Manual

Chapter 3 Basic Operation

Name of the button on the tool bar

The following commands are assigned to the buttons on the tool bar.
New
Button
New .................................................. Creates a new management file.
Open ............................................... Opens an existing management file.
Save ................................................. Saves the active management file.
Target monitoring ................. Starts or stops target monitoring.
Target display ........................... Displays selected target information.
Alert display ............................... Displays all of alert information on the status list.
Event log display .................... Displays all the event logs.
Command history display .. Displays all of the command history.
0 To switch the tool bar display on or off, select "Tool bar" from "Display" menu.

Icon display for the target

Displays icon according to the target condition.
Icon
Flat display type Projector type
10
Save
Open Target monitoring
Start/Stop
Operation
Condition
Normal
Abnormal condition (One of the abnormalities, Alert, Trap or System
error is happening on the target.)
Connection error (Target has been disconnected from the network)
Acquisition error (Target has been disconnected from the network, or
does not provide SNMP function.)
Unknown (Target monitoring is not operating)
Target display
Alert display
Command history display
Event log display