Speaker Components; Installing The Speakers On The Tallboy Stand - Samsung HT-D6750W 3D Blu-ray 7.1ch Home Entertainment System User Manual

Speaker Components

(L) (R)
FRONT/FRONT TOP STAND
(L)
SCREW (4x20): 16EA
SURROUND
SCREW (5x15): 8EA

Installing the Speakers on the Tallboy Stand

1. Turn the Stand Base upside-down and connect it to
the Stand.
2. Insert small screws (4x20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
!
CAUTION
When you use a torque screwdriver, be careful not
to put excessive force. Otherwise, it runs idle or
can be damaged. (torque screwdriver- below 15
kg.f.cm)
3. Insert the large screw (5x15, For connecting Stand
& Stand Base) clockwise into the hole on the rear of
the stand using a screwdriver.
4. Connect the upper Speaker to the assembled
Stand.
5. Insert another large screw (5x15, For connecting
Speaker & Stand) clockwise into the hole on the rear
of the speaker using a screwdriver.
6. This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
SUBWOOFER
(R)
Wireless Receiver Module
CENTER
1
3
5
SWA-5000
TX Card
Speaker Cable (2EA)
STAND BASE SPEAKER CABLE
2 2
Stand Base
Stand
4
Stand
6 6
English
Speaker
1