Rs-232C Command Table - Sharp PN-R703 Operation Manual

RS-232C command table

How to read the command table
Command: Command field (See page 33.)
Direction: W When the "Parameter" is set in the parameter field (see page 33), the command functions as described
under "Control/Response Contents".
R The returned value indicated under "Reply" can be obtained by setting "????", "
(repeater control) in the parameter field (see page 33).
Parameter: Parameter field (See page 33.)
Reply: Response (Returned value)
"●" indicates a command which can be used in power standby mode regardless of the STANDBY MODE setting.
* :
"○" indicates a command which cannot be used in power standby mode when STANDBY MODE is set to LOW POWER.
"–" indicates a command which cannot be used in power standby mode regardless of the STANDBY MODE setting.
Power control/Input mode selection
Function
POWER CONTROL
INPUT MODE SELECTION
Command Direction Parameter
0
POWR W
1
R
0
INPS W
1
2
3
4
9
10
12
13
14
R
Controlling the Monitor with a PC (RS-232C)
Reply Control/Response contents
Switches to standby mode.
Returns from standby mode.
0 Standby mode
1 Normal mode
2 Input signal waiting mode
Toggle change for input mode. Terminals not selected in INPUT SELECT cannot
be selected.
DVI-I
D-SUB[RGB]
"ERR" when other than RGB is selected for D-SUB of INPUT SELECT.
D-SUB[COMPONENT]
"ERR" when other than COMPONENT is selected for D-SUB of INPUT SELECT.
D-SUB[VIDEO]
"ERR" when other than VIDEO is selected for D-SUB of INPUT SELECT.
HDMI1[AV]
"ERR" when PC is selected for HDMI1 of INPUT SELECT.
HDMI1[PC]
"ERR" when AV is selected for HDMI1 of INPUT SELECT.
HDMI2[AV]
"ERR" when PC is selected for HDMI2 of INPUT SELECT.
HDMI2[PC]
"ERR" when AV is selected for HDMI2 of INPUT SELECT.
DisplayPort
1 DVI-I
2 D-SUB[RGB]
3 D-SUB[COMPONENT]
4 D-SUB[VIDEO]
9 HDMI1[AV]
10 HDMI1[PC]
12 HDMI2[AV]
13 HDMI2[PC]
14 DisplayPort
?" or "???+"
*
●
●
●
37
E