Internal Connectors - Asus P5WD2 Installation Manual

2.7.2 2.7.2

Internal connectors

Internal connectors
2.7.2 2.7.2 2.7.2 Internal connectors Internal connectors Internal connectors
1 . 1 . 1 . 1 . 1 . F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y ) F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y ) F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y ) F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y ) F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y )
This connector is for the provided floppy disk drive (FDD) signal cable.
Insert one end of the cable to this connector, then connect the other
end to the signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection
when using a FDD cable with a covered Pin 5.
®
P5WD2 Floppy disk drive connector
2 . 2 . 2 . I T E I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ E I D E [ r e d ] , S E C _ E I D E I T E I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ E I D E [ r e d ] , S E C _ E I D E
2 . 2 . I T E I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ E I D E [ r e d ] , S E C _ E I D E I T E I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ E I D E [ r e d ] , S E C _ E I D E I T E I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ E I D E [ r e d ] , S E C _ E I D E
[ r e d ] ) [ r e d ] ) [ r e d ] )
[ r e d ] ) [ r e d ] )
These connectors are for Ultra ATA 133/100/66 signal cables. The
ITE IDE connectors support up to four IDE hard disk drives for easier
data storage.
®
P5WD2 IDE connectors
The connectors do not support ATAPI devices.
A S U S P 5 W D 2 A S U S P 5 W D 2 A S U S P 5 W D 2
A S U S P 5 W D 2 A S U S P 5 W D 2
FLOPPY
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
SEC_EIDE
PRI_EIDE
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
PIN 1
2 - 2 9 2 - 2 9 2 - 2 9
2 - 2 9 2 - 2 9