Asus P5VDC-X Installation Manual page 40

2. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal
cables. There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to
the motherboardʼs IDE connector, then select one of the following
modes to configure your device(s).
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
Top:Line In
Center:Line Out
Below:Mic In
P5VDC-X
P5VDC-X IDE Connectors
1-28
Drive jumper
setting
Cable-Select or Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
R
Mode
of device(s)
-
Master
Slave
Master
Slave
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
Chapter 1: Hardware information
Cable
connector
Black
Black
Gray
Black or gray