Asus P5ND2-SLI Deluxe Manual page 55

5 . 5 . 5 . 5 . 5 . S i l i c o n I m a g e S e r i a l A T A R A I D c o n n e c t o r S i l i c o n I m a g e S e r i a l A T A R A I D c o n n e c t o r S i l i c o n I m a g e S e r i a l A T A R A I D c o n n e c t o r S i l i c o n I m a g e S e r i a l A T A R A I D c o n n e c t o r S i l i c o n I m a g e S e r i a l A T A R A I D c o n n e c t o r
( 7 - p i n S A T A _ R A I D 2 ) ( 7 - p i n S A T A _ R A I D 2 ) ( Deluxe model only ) ( 7 - p i n S A T A _ R A I D 2 ) ( 7 - p i n S A T A _ R A I D 2 ) ( 7 - p i n S A T A _ R A I D 2 )
This connector is for a Serial ATA signal cable. It supports a Serial ATA
hard disk drive that you can combine with an external Serial ATA
3Gb/s device to configure a RAID 0 or RAID 1 set through the
onboard Silicon Image SATA RAID controller. Refer to Chapter 5 for
details on how to set up Serial ATA RAID configurations.
See section "4.4.8 Onboard Devices Configuration" on page 4-32 for
details.
®
P5ND2-SLI Series SATA RAID connector
• Before creating a RAID set using Serial ATA hard disks, make sure
that you have connected the Serial ATA signal cable and installed
Serial ATA hard disk drives; otherwise, you cannot enter the Silicon
Image RAID utility and SATA BIOS setup during POST.
• Use this connector and an external Serial ATA box connected to the
external SATA port, if you want to configure a RAID 0 or RAID 1 set.
• The Serial ATA port multiplier and external Serial ATA box are
purchased separately.
DO NOT unplug the external Serial ATA box when a RAID 0 or RAID 1 was
configured.
A S U S P 5 N D 2 - S L I S e r i e s A S U S P 5 N D 2 - S L I S e r i e s
A S U S P 5 N D 2 - S L I S e r i e s A S U S P 5 N D 2 - S L I S e r i e s A S U S P 5 N D 2 - S L I S e r i e s
SATA_RAID2
2 - 2 9 2 - 2 9
2 - 2 9 2 - 2 9 2 - 2 9