Live Set-Up; Audio Connectors - Behringer EURODESK SX3242FX User Manual

14
EURODESK SX3242FX/SX2442FX User Manual

4.2 Live set-up

Bass
Drums
Guitar
K S O O
I N V V
Vocals 1
C A E E
K R R R
Vocals 2
E H H
D E E
R A A
U D D
M
L R
SUB 1-2 switch
pressed
SUB/MAIN switches
not pressed
Fig. 4.2: Wiring the console for live operation
This example shows a classic live set-up. As in the studio example, four drum
microphones, bass, keyboard (stereo channel), guitar and two vocal microphones
are connected. The four drum channels (kick drum, snare, overhead L, overhead R)
are mixed down to two subgroups and then routed to the main mix. This way,
it is possible to conveniently control the volume of the entire drums in the main
mix with the two subgroup faders. The built-in compressor insert effect is used
for the bass. The corresponding input channel is separate from all buses and the
bass signal is routed directly from the internal effects processor to the main mix
bus. The MAIN/SUB switch must not be pressed in this case and the position of the
SUB 1/2 SUB 3/4 switch is irrelevant.
Keyboard
L R
MAIN switch
pressed

5. Audio Connectors

The inputs and outputs of the BEHRINGER EURODESK are designed as unbalanced
¼" TS connectors—except for the balanced line inputs of the mono and stereo
channels and the main out connectors. Of course, all inputs and outputs work
with both balanced and unbalanced connectors. The tape ins and outs are stereo
RCA connectors.
◊
Unbalanced ¼" TS connector
Fig. 5.1: ¼" TS connector
L/R switch
pressed
Please ensure that only qualified personnel install and operate the
EURODESK. During installation and operation, the user must have
sufficient electrical contact to earth. Electrostatic charges might
affect the operation of the unit.
strain relief clamp
sleeve
tip
sleeve
(ground/shield)
tip
(signal)
EUROPOWER EP1500
2 x EUROLIVE PROFESSIONAL
Stack (B1800X PRO & B1220 PRO)
EUROPOWER EP1500
EUROLIVE PROFESSIONAL
B1220 PRO