Gigabyte GA-Z77-D3H User Manual page 25

F_AUDIO(H)
8) mSATA (Solid-State Drive Connector, Controlled by the Intel Z77/H77 Chipset)
The mSATA connector conforms to SATA 3Gb/s standard and can connect to a single solid-state drive.
When the mSATA connector is installed with a solid-state drive, the SATA2 5 connector will become un-
available.
DB_PORT
Voltage measurement module(X58A-OC)
PCIe power connector (SATA)(X58A-OC)
9) CLR_CMOS (Clear CMOS Jumper)
Use this jumper to clear the CMOS values (e.g. date information and BIOS configurations) and reset the
CMOS values to factory defaults. To clear the CMOS values, use a metal object like a screwdriver to
touch the two pins for a few seconds.
•
•
F_PANEL(NH)
BIOS Switcher (X58A-OC)
1
M_SATA
1
PWM Switch (X58A-OC)
3 2 1
DIP
DIP
1 2 3
Always turn off your computer and unplug the power cord from the power outlet before clear-
ing the CMOS values.
After system restart, go to BIOS Setup to load factory defaults (select Load Optimized De-
faults) or manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS
configurations).
mSATA
Open: Normal
Short: Clear CMOS Values
- 25 -
F_PANEL
(H61M-D2)
Hardware Installation