Page of 4

HP A8051A Installation Instructions

3dlabs wildcat iii 6110 graphics accelerator card.
Hide thumbs
   
Hewlett-Packard Company
3404 East Harmony Road
Fort Collins, Colorado 80528
General HP Installation Instructions
NOTE
Before you install your graphics card, refer to the your workstation's Technical
Reference (www.hp.com/go/workstationsupport) for important system
configuration information.
CAUTION
Graphic cards are susceptible to electrostatic shock. When handling your card
always wear a properly grounded wrist strap and handle the card carefully.
The latest workstation BIOS must be installed on your workstation before
installing the new graphics card. The latest BIOS can be downloaded from
http://www.hp.com/go/workstationsupport. If the latest BIOS is not installed, you
may experience no video, PCI Option ROM errors and system stops during self-
test (POST).
In addition, if you have purchased and/or installed Windows
driver must be installed to enable AGP. If an AGP graphics card is not run in
AGP mode, you may experience extremely slow graphics performance, system
lockups and Windows
http://www.hp.com/go/workstationsupport.
1.
Before opening your workstation to install the graphics card, disconnect all cables from the system. When refer-
ring to your system model/type and for obtaining the proper driver version, please use the AxxxxX nomenclature
found on the Serial Number plate on the back of the machine.
2. Following the procedures described in your workstation's Technical Reference, install the graphics board into the
AGP Pro slot (see the next diagram). Slide the board into the slot and ensure it is fully seated in the connector.
3.
Attach your monitor cable to the primary port. If you have two monitors, attach the primary monitor to the pri-
mary port and the second monitor to the secondary port. Use the included DVI-I dongle to attach an analog mon-
itor to the either port.
Read Before Installing
3DLabs Wildcat III 6110 Graphics Accelerator Card
HP Product No. A8051A
®
stop errors. The chipset driver can be downloaded from
®
2000, a chipset

Advertising

   Related Manuals for HP A8051A

   Summary of Contents for HP A8051A

  • Page 1

    Hewlett-Packard Company 3404 East Harmony Road Fort Collins, Colorado 80528 Read Before Installing 3DLabs Wildcat III 6110 Graphics Accelerator Card HP Product No. A8051A General HP Installation Instructions NOTE Before you install your graphics card, refer to the your workstation’s Technical Reference (www.hp.com/go/workstationsupport) for important system...

  • Page 2

    The type of service provided is return to an HP or repair-authorized reseller service-center. At Hewlett-Packard’s discretion, a defective accessory will be repaired or replaced by a new unit, either of the same type or of an equivalent model.

  • Page 3

    Regulatory Information FCC (for USA only) Federal Communications Commission Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and the Canadian Department of Communications. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

  • Page 4: Declaration Of Conformity

    European Contact: Your local Hewlett-Packard Sales and Service Office or Hewlett-Packard GmbH, Dept. HQ- TRE Standards Europe, Herrenberger Strasse 130 Boeblingen (FAX: +49-7031-14-3143) Americas Contact: Hewlett-Packard, Fort Collins Site Quality Mgr., Mail Stop 64, 3404 E. Harmony Road, Fort Collins, CO 80528, U.S.A.

Comments to this Manuals

Symbols: 0
Latest comments: