Advertisement
Available languages
Available languages
Attach pedestal to appliance
1.
Turn pedestal on its side to match orientation to appliance.
2.
Slide pedestal up to appliance and line up holes in mounting
brackets with holes in appliance base.
3.
Attach rear and front brackets to appliance base with supplied
screws into aligning holes - one in each front bracket and two in
each rear bracket.
4.
Using more than one person, carefully return appliance and ped-
estal to upright position.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person move
or lift the appliance.
IMPORTANT
DO NOT use open dispenser drawer of washer or dispenser
cavity as hand-hold location when tipping washer upright.
Serious damage could occur to your washer.
Installing or re-installing appliance
Washer on pedestal:
1.
Slide washer/pedestal into place.
2.
Check for levelness and rock all four (4) legs again. Repeat
until level and solid.
3.
Refer to Wa
sher Installation Instructions for complete details
on installing water, drain, or electrical.
5.
After retuning appliance upright, loosen each mounting screw
going into appliance base. Allow the appliance to settle in the
brackets and retighten each mounting screw.
WASHER:
DRYER:
Dryer on pedestal:
1.
Slide dryer/pedestal into place.
2.
Check for levelness and rock all four (4) legs again. Repeat
until level and solid.
3.
Refer to
Dryer Installation Instructions for complete details on
installing electrical, gas, or exhaust venting.
4
Advertisement
