G-Key Reset" Procedure - Compaq t1000 - Terminal Thin Client PC Network Installation Manual

T1500/T1510 Windows-Based Terminal Quick-Start Guide
7. To further configure the network setup, use the Select | System | Setup
window's Connectivity dialog boxes. Most of the information can be supplied
by your network administrator:
•
•
8. To ensure access to the on-line help after access to the network is established,
perform the following:
a. Press the Select button at the lower-left corner of the desktop and select
b. Press the Select button at the lower-left corner of the desktop again and
c. In the Setup window's Administration|Network Services dialog box, in the
END OF QUICK START INSTRUCTIONS - Make any other desired selections in
the remaining Setup window's dialog boxes. For more information, refer to the
complete help instructions, which you should now be able to access via the
network. It is suggested that before turning the terminal over to a user all
Connectivity and Administration settings be made and the Administrator and
VNC passwords be changed from their defaults to assure security.

"G-Key Reset" Procedure

You may reset the terminal software settings by using the G-Key Reset procedure:
• Turn on power and upon hearing the first beep immediately press the G key.
The beep occurs coincident with expansion of the splash screen to full window
size. The Login dialog box displays only if security is enabled, in which case
enter a valid administrator or user login name and password.
OR
For ethernet networking, make entries in the Internet dialog boxes.
For serial networking (network connection through a server), make entries in
the Serial Ports and Serial Internet dialog boxes. Press the Connect
button in the Serial Internet dialog box to make the connection.
System. In the Select | System pop up menu, select Browser Location. In
the Browser Launch dialog box, select Local, then select Save. (The local
browser is the default and normally is already selected, but you should
perform this step to be sure.)
select System. In the Select | System pop up menu, select Setup. This
opens the Setup window. The Setup window has a menu bar from which
dialog boxes may be opened.
Help text box enter the IP address and path where the detailed on line help
files reside. (The help files should be installed on a server by a network
administrator. Refer to the server setup instructions starting in Chapter 1 of
this document for instructions).
49