Replacement Procedures
4.14 CPU
Removing the CPU heat sink
The following describes the procedure for removing the CPU heat sink (See Figure 4-27).
1. Disconnect the MB from the connector on the system board
Disconnect VGA from the connector
2. Remove the following screws securing the heat sink holder and remove the thermal
module
• M2.5×5.0
• M2.5x 3.0
NOTE: When removing the heat sink holder, be sure to remove the screws in the reverse
order of the number marked on the holder.
3. Remove the CPU heat sink.
Satellite A300 Maintenance Manual(960-Q08)
BIND screw
BIND screw
Figure 4-27 Removing the CPU heat sink
x2
x4
39