Installing The Battery Pack; Starting The Computer By Password - Toshiba PSMD8C-02100K User Manual

Installing the battery pack

To install a battery, follow the steps below.
■
The battery pack is a lithium ion battery, which can explode if not
properly replaced, used, handled or disposed of. Dispose of the battery
as required by local ordinances or regulations. Use only batteries
recommended by TOSHIBA as replacements.
■
Do not touch the latch while holding the computer. Or you may get
injured by the dropped battery by unintentional release of the latch.
1. Turn the computer's power off.
2. Disconnect all cables connected to the computer.
3. Insert the battery pack.
4. Ensure the battery pack lock is moved into its locked position.

Starting the computer by password

If you have already registered a password, there are two ways to start the
computer:
Swipe your fingerprint on the sensor if you have already registered the
fingerprint with the Fingerprint utility and enabled Fingerprint Power-on
Security. If you would not like to swipe your finger or cannot authenticate
the fingerprint for some reasons, push the BACK SPACE key to skip the
fingerprint authentication screen. You can try to swipe the fingerprint up to
five times. If you failed fingerprint authentication more than five times, you
must enter the password manually to start the computer. Enter the
password manually.
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 3,
following message appears:
User's Manual
Battery
Pack
Lock
Password=
Battery pack
Securing the battery pack
Power and Power-Up Modes
Getting Started. The
6-13