Panasonic DMC-TS3D Basic Owner's Manual page 35

Crash resistance
perfomance
Dustproof
performance
Battery Charger (Panasonic DE-A59B):
Information for your safety
Input:
Output:
Operating
temperature:
Equipment mobility:
Battery Pack (lithium-ion) (Panasonic DMW-BCF10PP):
Information for your safety
Voltage/capacity:
The test method of the camera is in compliance with
"MIL-STD 810F Method 516.5-Shock"
¢ "MIL-STD 810F Method 516.5-Shock" is the test
method standard of the U.S. Defense Department,
which specifies performing drop tests from a height
of 122 cm (4.0 feet), at 26 orientations (8 corners,
12 ridges, 6 faces) using 5 sets of devices, and
passing the 26 orientation drops within 5 devices.
(If failure occurs during the test, a new set is used to
pass the drop orientation test within a total of 5
devices)
•
Panasonic's test method is based on the above
"MIL-STD 810F Method 516.5-Shock". However, the
drop height was changed from 122 cm (4.0 feet) to
200 cm (6.6 feet) dropping onto 3 cm (0.10 feet) thick
plyboard. This drop test was passed.
(Disregarding appearance change such as loss of paint
or distortion of the part where drop impact is applied.)
There is no guarantee of not breaking or
malfunctioning under all conditions.
Equivalent to IEC 60529 "IP6X".
110 V to 240 V
4.2 V 0.65 A
¢
0 oC to 40 oC (32 o F
¢ The battery cannot be recharged in a temperature
less than 0 oC (32 oF). (The [CHARGE] indicator
blinks when the battery cannot be recharged.)
Movable
3.6 V/940 mAh
50/60 Hz, 0.2 A
¢
to 104 o F)
¢
.
(ENG) VQT3L22
35