Asus P2V-B User Manual page 36

III. HARDWARE SETUP
21. ATX Power Supply Connector (20-pin ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT:
10mA on the 5-volt standby lead (+5VSB). You may experience difficulty in
powering on your system if your power supply cannot support the load. For
Wake-On-LAN support, your ATX power supply must supply at least 720mA.
P2V-B
P2V-B ATX Power Supply Connector
22. AT Power Supply Connector (12-pin PS/2)
This connector connects to a standard 5 Volt power supply. To connect the leads
from the power supply, ensure first that the power supply is not plugged. Most
power supplies provide two plugs (P8 and P9), each containing six wires, two of
which are black. Orient the connectors so that the black wires are together.
P2V-B
P2V-B AT Power Supply Connector
Using a slight angle, align the plastic guide pins on the lead to their receptacles
on the connector. Once aligned, press the lead onto the connector until the lead
locks into place.
36
Make sure that your ATX power supply can supply at least
Power Supply On
R
-5V
-12V
+5V
R
Power Connector
on Motherboard
ASUS P2V-B User's Manual
+3.3 Volts
+3.3 Volts
+3.3 Volts
-12.0 Volts
Ground
Ground
+5.0 Volts
Ground
Ground
+5.0 Volts
Ground
Ground
Ground
Power Good
-5.0 Volts
+5V Standby
+5.0 Volts
+12.0 Volts
+5.0 Volts
RED
RED
+5V
RED
WHT
BLK
BLK
GND
BLK
BLK
BLU
YLW
+12V
RED
ORG
PG
Power Plugs from
Power Supply
P9
P8