Table of Contents
Advertisement
III. HARDWARE SETUP
18. Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that PWR UP On Modem Act Power Up Con-
trol is set to Enabled (see Power Management Setup under BIOS SETUP) and that your
system has an ATX power supply with at least 720mA +5V standby power.
P2V-B
P2V-B Wake-On-Ring Connector
19. Chassis Intrusion Sensor Lead (4-1 pin CHASIS)
This lead is for a chassis intrusion monitor or sensor. The sensor is triggered
when a high level signal is sent to the "chassis signal" lead. This occurs when a
panel switch or light detector is triggered. This function requires the optional
ASUS CIDB Chassis Intrusion Photo Sensor Module (see APPENDIX) to be
installed.
P2V-B
P2V-B Chassis Intrusion Sensor Lead
34
WOR
R
R
ASUS P2V-B User's Manual
Pin 2 PIXRI#
Pin 1 Ground
Advertisement
Table of Contents
