Brother BE-0901E-AC Programming Instructions Manual page 13

The screen should appear as such:
The Short Pit speed limit feature will have to be programmed again
when the CAP mode is selected. Power off the machine, and change
the black frame mode switch from FLAT to CAP. Power "ON" the
machine and press the twice, (allow time for the screen to
accept each key selection). Press the key until the short pit
speed limit feature is selected. Press the key. Press
the key to remove the slashes, activating the feature. The
recommended settings are 1.1 mm and 600 SPM. Use the
keys to set those values.
Press the key to accept the new settings.
Press the key to return to the main screen.
If the machine is to continue in the tubular/flat mode, power off and
turn the frame mode switch back to the "Flat" position.
13