Table of Contents
Advertisement
NEW LQ-850/1050+ DOT-MATRIX PRINTER
Installation/Support Tips
Short Tear Off
To activate the short tear-off feature on the printer, first turn DIP
switch 2-7 to the on position. To control it through the software,
send a form feed command at the end of each page. After
sending a form feed, do not send it any more data for a 3-
second interval/
Single-Sheet Loading
When loading single sheets, make sure that the paper lever is
set to single sheets, not tractor paper. The paper can be loaded
manually or via auto load. Before attempting to load in the
paper, wait for the platen to lock in place after changing the
paper lever.
Setting up the Page Length
The page length has to be adjusted for using single sheets and
for using tractor paper. When your software you asks you to set
up the number of lines/page, single sheets require a shorter
page length than does tractor paper. Set the page length to 61
lines for single sheets (also when using the cut-sheet feeder)
and 66 lines for tractor paper.
Software
The type of printer installed on your system must be identified
for each software package. This is usually done through a setup
menu. If the LQ-850/1050+ is not listed in the software
package, any Epson 24-pin driver will be compatible.
DIP Switch Settings
The default settings will usually work for most applications, but
they should be checked before using the printer. This will avoid
unexpected results.
NEW
LQ-850/1050+-8
12/31/90
24-Pin Printers
Advertisement
Table of Contents
