Asus Maximus Formula - Republic of Gamers Motherboard User Manual page 60

8. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default , the pin labeled "Chassis Signal" and "Ground" are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
MAXIMUS FORMULA
MAXIMUS FORMULA(Special Edition)/
MAXIMUS FORMULA Chassis intrusion connector
9. ATX power connectors (24-pin EATXPWR, 8-pin EATX12V)
These connectors are for ATX power supply plugs. The power supply plugs
are designed to fit these connectors in only one orientation. Find the proper
orientation and push down firmly until the connectors completely fit.
MAXIMUS FORMULA
MAXIMUS FORMULA(Special Edition)/
MAXIMUS FORMULA ATX power connectors
•
•
2-34
GND
GND
GND
GND
Make sure to remove the cap on the EATX12V connector before connecting
an 8-pin EPS +12V power plug.
Use only an 8-pin EPS +12V power plug for the EATX12V connector.
CHASSIS
(Default)
EATX12V
+5V Standby
+12V DC
+12V DC
+12V DC
+12V DC
Chapter 2: Hardware information
EATXPWR
+3 Volts Ground
+12 Volts +5 Volts
+12 Volts +5 Volts
+5 Volts
Power OK -5 Volts
Ground Ground
+5 Volts Ground
Ground Ground
+5 Volts PSON#
Ground Ground
+3 Volts -12 Volts
+3 Volts +3 Volts