NETGEAR WNR3500Lv1 Setup Manual page 8

N300 wireless gigabit router
Hide thumbs Also See for WNR3500Lv1:
Table of Contents

Advertisement

Figure 3
Getting to Know Your Wireless Router
Power
On – Amber
On – Green
Blink – Amber
Blink – Green
Off
Internet
On – Amber
On – Green
Blink – Green
Off
Wireless
On – Blue
Blink – Blue
Off
LAN (Ports 1–4)
On – Green
Blink – Green
On – Amber
Blink – Amber
Off
WPS button/light
Blink – Green
On – Green
The router is performing the power-on self-test diagnostic.
The power is on and the router is ready.
A software update is in progress.
The firmware is corrupt. See
Functions" on page 31
firmware.
Power is not being supplied to the router.
No IP address acquired.
The N300 Wireless router has acquired an Internet address.
Data is being communicated with the Internet.
No Ethernet cable is connected to the modem.
The wireless interface is enabled.
Data is being communicated over the wireless network.
The wireless interface is turned off.
The local port is connected to a 1000 Mbps device.
Data is being transmitted at 1000 Mbps.
The local port is connected to a 10/100 Mbps device.
Data is being transmitted at 10/100 Mbps.
No link is detected on this port.
Indicates WPS activity; the device is in the 2 minute interval
to synchronize security or there is a WPS error.
Security set to WEP, WPA-PSK, or WPA2-PSK.
"Checking Basic Router
for instructions on restoring your
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wnr3500l

Table of Contents