Troubleshooting; Checking Error Messages - LG WT1101CW Owner's Manual

TROUBLESHOOTING

Checking error messages

If the following message appears on the display, check the following and take the appropriate corrective action.
Message
Water in the washer y Drain hose is bent, pinched, or clogged.
drains slowly or not
at all, or the display
shows:
Washer fills with water y Water supply taps are not open fully.
slowly or not at all, or y Water line hoses are kinked, pinched, or
the display shows: bent.
y Water inlet filters are clogged.
y Water pressure to tap or house is too low.
Washer will not turn on y Power cord is not properly plugged in.
y House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
The display shows: The lid is not closed properly.
The display shows: y Lid lock switch error
The display shows: y Water level is too high due to a faulty water
valve.
The display shows: y Clutch error
Possible Causes
y Make sure the drain hose is free of clogs, kinks, etc.,
y Make sure that the water taps are open fully.
y Clean the inlet filters. See the Care and Cleaning
y Check another faucet in the house to make sure that
y Make sure that the plug is plugged securely into a
y Reset circuit breaker or replace fuse. Do not increase
y Make sure that the lid is closed properly and press the
y If the lid is closed and locked and the open lid error
y If you press the START button while the lid is open, dE
y Make sure that the lid is closed properly and press the
y If the lid is closed and the lid lock error message is
y Close the water taps, unplug the washer, and call for
y Unplug the washer, and call for service.
TROUBLESHOOTING
Solutions
and is not pinched behind or under the washer.
Make sure the hoses are not kinked or pinched. Be
careful when moving the washer.
section.
household water pressure is adequate.
grounded, 3-prong, 120-VAC, 60-Hz. outlet.
fuse capacity. If the problem is a circuit overload, have
it corrected by a qualified electrician.
START/PAUSE button. After starting a cycle, it may
take a few moments before the drum begins to turn or
spin. The washer will not spin unless the lid is locked
(LID LOCK light will turn on).
message is displayed, call for service.
error message will be displayed.
START/PAUSE button. The washer will not spin unless
the lid is locked (LID LOCK light will turn on).
displayed, call for service.
service.
29