Table of Contents
Advertisement
Important Notes
Keep this user's manual for future reference. It contains important information on product setup and
configuration.
Visit the following website for software update and last-minute changes to this document:
http://www.sednacomputer.com/products/se-nas-05.html
Default Factory Setting
Administrator user name =
Administrator password =
Host name = storage-XXXX, where
SE-NAS-05, printed on the back panel.
IP address:
169.254.0.1
Restore Default Factory Setting
1.
Power off the SE-NAS-05
2.
Press and hold the reset button
3.
Power on the SE-NAS-05 and then wait for at least 10 seconds
4.
Release the reset button.
Disclaimer
1. All contents and specification mentioned in this manual are subject to change without prior notice.
2. All brand names and trademarks referenced and mentioned in this manual are property of their respective
owners.
3. Make sure you use the power supply came with the SE-NAS-05. Using third-party's power supply with different
output voltage and power rating than that came with this product may result in permanent damage to the
SE-NAS-05 and hard drive.
4. In case of a high electrostatic discharge and fast transient disturbance from the power source, you may need to
power off the device manually, wait for a few seconds before powering it on again.
admin
admin
XXXX
is the last four digits of MAC address (physical address) of
2
Advertisement
Table of Contents
