Table of Contents
Advertisement
Operating Features
Autoprogramming Channel Memory
The Channel Memory is the list of TV
channel numbers your TV will stop on
when you press the CHANNEL up or
down button. You can program any
list of channels into the channel
memory although your TV is so
automatic that you will probably never
need to manually operate this feature.
If you do, follow the instructions at
the right.
The first time you turn on the TV, it
cycles through all channels and places
active channels into the channel
memory. You can then add or erase
channels as desired by following the
instructions in the "Editing Channel
Memory" section at the right.
Notes:
• Signals from scrambled cable channels and
some cable channels having unusual signal
conditions may not be autoprogrammed.
• To prevent the TV from losing its channel
memory, make sure the outlet you plug your
TV into is "on" all the time. Do not plug
the TV into an outlet that can be turned on
and off by a wall switch. Also do not plug
the TV into an outlet on the back of another
device (such as a cable-TV converter box)
that is turned off when the device is turned
off.
• If there is an extended power failure, your
TV will automatically reprogram active
channels the first time you turn it on after
the power failure.
12
1. Connect home antenna(s) or cable to
your set.
2. Press MENU until SETUP is high
lighted. Press + to select the SETUP
menu.
ENGLISH
VIDEO
CAPTION OFF
-
SETUP
3. Repeatedly press MENU until
AUTOPROGRAM is highlighted.
– AUTOPROGRAM +
– AUTOPROGRAM +
EDIT CHANNELS
EDIT CHANNELS
ANTENNA:CABLE
ANTENNA:CABLE
LIST FEATURES
4. Press + to begin Autoprogramming.
The TV cycles through all channels
and places only active channels into
memory.
AUTOPROGRAM 24
5. When the TV finishes cycling, you can
check the channels in memory by
pressing CHANNEL up or down.
Editing Channel Memory
Follow these instructions to erase and add
channels.
1. Press MENU until SETUP is high
lighted. Press + to select the SETUP
menu.
+
-
2. Repeatedly press MENU until EDIT
CHANNELS is highlighted. Press + to
select EDIT CHANNELS.
– AUTOPROGRAM +
2nd
SETUP
Menu
3. Select the channel number by pressing
CHANNEL up or down or two number
buttons on the remote.
When "+" appears next to the channel
number, the channel is in the channel
list. Press – to erase the channel.
When "–" appears next to the channel
number, the channel is not in the
channel list. Press + to add the
channel.
4. Press – to erase or press the + to add.
ENGLISH
VIDEO
CAPTION OFF
SETUP
+
– AUTOPROGRAM +
EDIT CHANNELS
EDIT CHANNELS
ANTENNA:CABLE
ANTENNA:CABLE
LIST FEATURES
–
12
– ERASE / ADD +
2nd
SETUP
Menu
Advertisement
Table of Contents
