Table of Contents
Advertisement
Problem:
Remote Control Unit
does not work.
Wireless Mouse
function does not
work.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If the problem still persists after following all operating instructions, contact the sales dealer where you purchased the
projector or the service center. Give the model number and explain the difficulty. We will advise you how to obtain service.
The CE Mark is a Directive conformity mark of the European Community (EC).
G Check batteries.
G Check ALL-OFF switch on Remote Control Unit is set to "ON".
G Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.
G Make sure you are not too far from a projector when using Remote Control Unit.
Maximum operating range is 16.4' (5m).
G Check transmitted signal mode from Remote Control Unit.
(See"SETTING" section on page 39.)
G Check cable connection between a projector and your computer.
G Check mouse setting on your computer.
G Turn a projector on before turning on a computer.
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and electrical hazards.
Try these Solutions
APPENDIX
47
Advertisement
Table of Contents
