Quick Installation - ViewSonic TD2220 User Manual

Quick Installation

Quick Installation
1. Connect power cord (and AC/DC
adapter if required)
2. Connect video cable
• Make sure both the LCD display and
computer are turned OFF
• Remove rear panel covers if necessary
• Connect the video cable from the LCD
display to the computer
Macintosh users: Models older than G3
require a Macintosh adapter. Attach the
adapter to the computer and plug the video
cable into the adapter.
To order a ViewSonic
adapter, contact ViewSonic Customer
Support.
3. Turn ON LCD display and computer
Turn ON the LCD display, then turn ON
the computer. This sequence (LCD display
before computer) is important.
NOTE: Windows users may receive a
message asking them to install the INF
file. This is on the DVD.
4. Insert the ViewSonic Wizard DVD into
the computer's DVD drive.
Follow the on-screen instructions. If your
computer does not have a DVD-ROM
Power Cord
AC Outlet
(Wall Socket)
®
Macintosh
Audio In
AC IN
USB UP
USB DOWN
Computer Power Cord
6
drive, please refer to Customer Support
page.
• Wait for the DVD-ROM to auto-start.
NOTE: If the DVD-ROM does not auto-
start: double-click on the DVD-ROM icon
in the Windows Explorer, then double-
click on viewsonic.exe.
• Follow the on-screen instructions.
5. Windows users: Set the timing mode
(resolution and refresh rate)
Example: 1920 x 1080 @ 60 Hz.
For instructions on changing the
resolution and refresh rate, see the
graphics card's user guide.
Installation is complete. Enjoy your new
ViewSonic LCD display.
To be best prepared for any future
customer service needs: print this user
guide and write the serial number in "For
Your Records" on page 4. (See back of
LCD display.)
You can register your product online at the
ViewSonic website for your region. See
the Customer Support table in this guide.
The ViewSonic Wizard DVD-ROM also
provides an opportunity for you to print
the registration form which you may mail
or fax to ViewSonic.
DVI
D-Sub