Master Section Features; Lamp Connector; Aux Send Master; Aux Send Masters - Mackie SR24.4-VLZ PRO Owner's Manual

MASTER SECTION FEATURES

22
In the master section, signals leaving the
channel strips are mixed, manipulated and
sent to the outputs in the patchbay. Addition-
ally, there are four more stereo inputs here,
used to add effects to the main mix or other
destinations.
45. LAMP
This female BNC connector provides 12
volts on its center pin. Connect any quality
gooseneck lamp here.
AUX SEND MASTER: (46 and 47)

46. AUX SEND MASTERS

Aux send signals originate at each channel's
AUX (26) knobs, are mixed together, sent
through these controls, and exit at the
patchbay's AUX SENDS (10). Turned fully up,
these controls provide 15 dB of additional gain,
the center "U" label is unity gain and fully down
is off.
When an aux send is used for monitors,
these knobs can be used to raise or lower indi-
vidual monitor mixes to suit the performer's
taste. For recording work, these knobs are typi-
cally set near unity and left alone; most
adjustments are made per channel.

47. SOLO

Engaging any of these switches will isolate
the associated signal and send it to the control
room, phones and meters. See RUDE SOLO
LIGHT (61) and MODE (63) for more informa-
tion.