Advertisement
Assembly
1. Slide handle onto vacuum base, tighten with longer screws
2. Attach hose rack to back of vacuum. Feed power cord through center opening
3. Tighten with shorter screws
4. Identify tabbed end of hose and lock into left opening
5. Feed opposite end of hose into holder on lower right, press down firmly
to engage the white suction diverter
6. Slide crevice tool into extension wand and store in clip
7. Snap combination tool into storage clip
8. Attach TurboBrush Tool to handle
1.
2.
4.
5.
7.
8.
3.
6.
Your assembly is
now complete.
Ready to vacuum
1. Adjust height for carpet or bare floor
2. Plug into electrical outlet and turn power on by pushing the power button
located on upper handle
3. Step on handle release to lower into cleaning position
4. Be sure to press rotating brush switch on located next to power button
5. Attach tool for above floor and stair cleaning
6. Empty dirt cup after each use
1.
4.
For complete users guide visit www.bissell.com
2.
3.
5.
6.
Advertisement
