HP Vectra VL6 6 Installation Manual page 3

1 Connecting to a Netware 3.12 Server
Windows for Requirements
Workgroups
• HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.
• 3COM Etherlink 3C900 Ethernet card and drivers disk ver 2.1.
• DOS and MS-Windows for Workgroups 3.11 media.
• Novell Netware server that supports Net BEUI, NWLink IPX/SPX, and
• Netware client for DOS and MS-Windows.
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
• I/O Base Address
• Interrupt Request Level
Procedure
1 With the HP Vectra turned off install the 3COM Etherlink III 3C900
2 Power on the machine and allow it to boot to a DOS prompt.
3 Insert the 3COM drivers diskette (ver. 2.1 downloaded from 3COM's
4 Select "CONFIGURE NIC," and verify the resource settings listed above
5 If changes are required, save those changes and exit.
6 Remove the 3com cards driver diskette and insert Netware client for DOS
DOS ODI - File Name: 3C90X.COM Size: 59KB Date: 12/18/96
NWLink NetBIOS transfer protocols.
adapter card into a PCI slot.
website) and execute 3C90XCFG.EXE.
under the heading "Device Configuration."
and MS-Windows disk 1.
1 Connecting to a Netware 3.12 Server
Windows for Workgroups
Normal
Disabled
Disabled
10BASE-T
FCC0h (PCI)
9 (PCI)