Gigabyte GA-7TESH2-RH User Manual page 26

GA-7TESH2-RH Motherboard
15 ) BAT (Battery)
If you want to erase CMOS...
1.Turn OFF the computer and unplug the power cord.
2.Remove the battery, wait for 30 second.
3.Re-install the battery.
4.Plug the power cord and turn ON the computer.
16~23 ) CPU_FAN1/2 / SYS_FAN1/2/3/4/5/6 (CPU fan / System fan cable connectors)
The cooler fan power connector supplies a +12V power voltage via a 3-pin/4-pin(CPU_FAN) power
connector and possesses a foolproof connection design.
Most coolers are designed with color-coded power connector wires. A red power connector wire
indicates a positive connection and requires a +12V power voltage. The black connector wire is the
ground wire (GND).
Remember to connect the CPU/system fan cable to the CPU_FAN/SYS_FAN connector to prevent
CPU damage or system hanging caused by overheating.
CPU2 FAN
SYS FAN3
SYS FAN2
SYS FAN4
 Danger of explosion if battery is incorrectly
replaced.
 Replace only with the same or equivalent
type recommended by the manufacturer.
 Dispose of used batteries according to the
manufacturer's instructions.
SYS FAN5
SYS FAN6
CPU1 FAN
SYS FAN1
2 6
CAUTION
1
1
Pin No. Definition
1 GND
2 12V
3 Sense
4 Control