Charging Time; To Remove The Battery Pack - Sony HDR-GW77V "Handycam User Manual

The CHG (charge) lamp (
The CHG (charge) lamp turns off when the battery pack is fully charged. Disconnect the USB
cable from the USB jack of your camcorder.
5. Close the battery/memory card/jack cover.
Flip the battery/memory card/jack cover back (
until the yellow mark of the cover lock lever is hidden.
Notes
You cannot insert any battery pack other than an NP-BG1 (supplied) or NP-FG1 (sold separately)
into your camcorder.
You cannot use a Sony CP-AH2R, CP-AL, or AC-UP100 portable power supply device (sold
separately) to charge camcorder.
In the default setting, the LCD screen turns dark if you do not operate the camcorder for about 1
minute, and the power turns off if you do not opearate the camcorder for 2 minutes, to save battery
power ([Power Save]).

Charging time

Approximately 140 minutes required when you fully charge a fully discharged battery pack with AC
Adaptor.
The charging times shown in the table above are measured when charging the camcorder at a
temperature of 25 °C (77 °F). It is recommended that you charge the battery in a temperature range
of 10 °C to 30 °C (50 °F to 86 °F).

To remove the battery pack

1. Close the LCD screen, then slide down and open the battery/memory card/jack cover while sliding
and holding the cover lock lever.
2. Slide the battery release lever (
) turns on.
) and remove the battery pack (
37
), then slide ( ) and close the cover firmly
).