Firewall - Edimax Wireless VPN Broadband Router User Manual

Hop Count
Interface
Add a Rule
Remove a Rule
Click <Apply> at the bottom of the screen to save the above
configurations. You can now configure other advance sections or start
using the router (with the advance settings in place)

2.7 Firewall

The Broadband router provides extensive firewall protection by restricting
connection parameters, thus limiting the risk of hacker attack, and
defending against a wide array of common Internet attacks. However, for
applications that require unrestricted access to the Internet, you can
configure a specific client/server as a Demilitarized Zone (DMZ).
Note: To enable the Firewall settings select Enable and click Apply
The number of hops (routers) to pass through to
reach the destination LAN.
The interface that go to the next hop (router).
Fill in the "Destination LAN IP", "Subnet Mask",
"Default Gateway", "Hop Count" and "Interface" of
the rule to be added and then click "Add". Then
this rule of Static Routing will be added into the
"Static Routing Table" below. If you find any typo
before adding it and want to retype again, just
click "Reset" and the fields will be cleared.
If you want to remove some routing rules from the
"Static Routing Table", select the rules you want
to remove in the table and then click "Delete
Selected". If you want remove all rules from the
table, just click "Delete All" button. Click "Reset"
will clear your current selections.
64